Seca 955 Manuel d'utilisateur télécharger pdf (Page 19)

Operation • 19

English

Tare off additional

weight (TARE)

You can use the TARE function to prevent the weighing

result from being affected by an additional weight (e.g.

a towel or pad on the weighing surface).

ATTENTION!

Incorrect measurement with force shunt

If an additional weight (e.g. large towel) is in

contact with the surface on which the scales

are standing, the weight will not be measured

correctly.

– Make sure that any additional weight is only

placed on the weighing surface of the scales.

1. Switch the scale on.

2. Place the additional weight on the scales.

3. Hold down the arrow key (hold/tare) until "NET"

appears in the display.

4. Wait until the display stops flashing and is replaced

0.00.

5. Weigh the patient as described in section “Start

weighing”.

6. Read off the measured result.

The additional weight has been automatically

deducted.

7. To disable the TARE function, press the arrow key

(hold/tare) until "NET" no longer appears in the

display or switch off the scales.

NOTE:

The maximum weight that can be displayed is

reduced by the weight of the objects already

placed on the scales.

Continuous display of

measured

result (HOLD)

If you activate the HOLD function, the weighing value

will continue to be displayed after the load has been

removed. This allows you to attend to the patient

before noting down the weight.

1. Check that there is no load on the scales.

2. Switch the scale on.

3. Weigh the patient as described in section “Start

weighing”.

4. Briefly press the arrow key (hold/tare).

tare

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 34 35

Commentaires sur ces manuels

Pas de commentaire

Seca 955 Manuel d'utilisateur Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Échelles Seca 955