Seca 274 band_1 Manuel d'utilisateur télécharger pdf (Page 52)

52 •

2. Keep the brake button pressed and move the head

slide until a length value appears in the display.

ATTENTION!

Incorrect measurement as a result of

incomplete calibration.

The height value displayed does not

correspond to the actual position of the head

slide.

− Complete the calibration as described in this

section.

3. Position the calibration rod supplied (length 0.8 m)

vertically on the base of the device and hold it in this

position.

4. Keep the brake button pressed and push the head

slide onto the calibration rod.

5. Simultaneously press the Enter key (send/print)

and the arrow key (hold/zero) to open the menu.

The last menu item selected is shown in the display

(here: “bEEP”).

6. Press the arrow key (hold/zero) until "CAL"

appears in the display.

7. Confirm your selection with the Enter key (send/

print).

8. Use the arrow key (hold/zero) to select the “Yes"

setting.

9. Confirm your selection with the Enter key (send/

print).

The display “Auto” appears.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 254 255

Pas de commentaire

Seca 274 band_1 Manuel d'utilisateur Page 52