Seca 274 band_1 Manuel d'utilisateur télécharger pdf (Page 51)

Before you get started … • 51

English

4.5 Connecting the power supply

The head slide is supplied with power from batteries.

The batter holder supplied already contains 4 Mignon

batteries, type AA, 1.5 volt. To connect the power

supply for the head slide, proceed as follows:

1. Remove the cover of the battery compartment.

2. Remove the connection cable from the battery

compartment.

3. Connect the battery holder to the connection cable.

4. Insert the battery holder into the battery

compartment.

ATTENTION!

Damage to device and malfunction due to

clamped or pinched cable

− Lay the battery cable before closing the

battery compartment so that it cannot get

clamped between the cover and the battery

compartment.

5. Slide the cover onto the battery compartment until

it audibly latches into position.

4.6 Calibrate head slide

Before you can measure height using the device for the

first time, you have to calibrate it. You do so by

“teaching” the device a reference measurement.

Automated calibration You can perform automated calibration using the

calibration rod supplied.

1. Press the Start key of the head slide.

“----” appears in the display.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 254 255

Pas de commentaire

Seca 274 band_1 Manuel d'utilisateur Page 51